Aerogen Solo Use:
Non-Invasive Ventilation
Follow this set up guide to understand how to use Aerogen Solo for Continuous or 6 hour mode Nebulisation.
Scroll to review the steps below
STEP 1
Place the Aerogen Solo firmly into the Aerogen T-piece
Ensure correct orientation of the device
STEP 2
Insert the Aerogen Solo and the Aerogen T-piece between the mask and the exhalation port* of the single limb NIV circuit using a non-vented mask
*Leak port or exhalation Valve.
STEP 3
Insert medication into the Aerogen Solo
STEP 4
Connect the Aerogen Controller Cable to the Aerogen Solo and the Aerogen Pro-X/USB Controller
STEP 5
Press and hold the on/off button from the off position for
1 SECOND
Press and hold the on/off button from the off position for
3 SECONDS
Section Five | Product set up for NIV
Copyright © 2025 Aerogen Ltd. All rights reserved. AerICU, Aerogen, Aerogen Go, Aerogen Solo, Aerogen Ultra, Go, The WheeZees and Vibronic are trademarks or registered trademarks of Aerogen Ltd or its affiliates.
